Prohledat stránky podpory

Vyhněte se podvodům. Za účelem poskytnutí podpory vás nikdy nežádáme, abyste zavolali nebo poslali SMS na nějaké telefonní číslo nebo abyste sdělili své osobní údaje. Jakékoliv podezřelé chování nám prosím nahlaste pomocí odkazu „Nahlásit zneužití“.

Zjistit více

How do I make the down arrow at the right of the tab bar visible?

  • 2 odpovědi
  • 1 má tento problém
  • 1 zobrazení
  • Poslední odpověď od FredMcD

more options

The down arrow at the right end of the tab bar is no longer visible. If I enter 'Customise', the arrow is faintly visible and I believe I could drag it onto the Customise page.

I can find no reference to it in my userChrome.css file. If the width of the tab bar and tabs is set to 100vw, there is vacant space at the right end of the tab bar but only the + to open a new tab is visible.

None of the suggestions about "Troubleshooting Information" work.

The down arrow at the right end of the tab bar is no longer visible. If I enter 'Customise', the arrow is faintly visible and I believe I could drag it onto the Customise page. I can find no reference to it in my userChrome.css file. If the width of the tab bar and tabs is set to 100vw, there is vacant space at the right end of the tab bar but only the + to open a new tab is visible. None of the suggestions about "Troubleshooting Information" work.

Zvolené řešení

After posting this I revised my Duckduckgo search terms and found the following archived thread : https://support.mozilla.org/en-US/questions/925527

The workaround is to use 'Customise' and drag the arrow to the extreme left of the tab bar where it happily remains visible (so far).

A solution of sorts.

Přečíst dotaz v kontextu 👍 0

Všechny odpovědi (2)

more options

Zvolené řešení

After posting this I revised my Duckduckgo search terms and found the following archived thread : https://support.mozilla.org/en-US/questions/925527

The workaround is to use 'Customise' and drag the arrow to the extreme left of the tab bar where it happily remains visible (so far).

A solution of sorts.

Upravil uživatel ender21 dne

more options

That was very good work. Well done. Please flag your last post as Solved Problem so others will know.