Avatar for Username

Iskanje po podpori

Izogibajte se prevarantski tehnični podpori. Nikoli vam ne bomo naročili, da pokličete telefonsko številko ali nam pošljete osebne podatke. Sumljivo dejavnost prijavite z gumbom »Prijavi zlorabo«.

Več o tem

Ta tema je arhivirana. Postavite prosim novo vprašanje, če potrebujete pomoč.

Connection timeout setting on page refresh

  • 1 odgovor
  • 1 ima to težavo
  • 1 ogled
  • Zadnji odgovor od jpnyc

jpnyc
jpnyc
more options

I have a computer I use to monitor the status of several servers via a web page which contains multiple iFrames. The iFrames have http-equiv="refresh" in them which updates the frame every few minutes. When I wake the computer from sleep it takes 30 seconds for the network card to wake up and the auto refresh is failing . Prior to upgrading from FF 28 everything was fine, but now I am getting "The connection was reset" in the frames.

I tried adjusting network.http.response.timeout and network.http.connection-timeout but still have the problem.

I have a computer I use to monitor the status of several servers via a web page which contains multiple iFrames. The iFrames have http-equiv="refresh" in them which updates the frame every few minutes. When I wake the computer from sleep it takes 30 seconds for the network card to wake up and the auto refresh is failing . Prior to upgrading from FF 28 everything was fine, but now I am getting "The connection was reset" in the frames. I tried adjusting network.http.response.timeout and network.http.connection-timeout but still have the problem.

Vsi odgovori (1)

jpnyc
jpnyc Lastnik vprašanja
more options

I just did a little more testing and the results are confusing me:

With F50 installed, if I hibernate, when the computer wakes I get the connection error on the page with auto refresh. I reinstalled FF28, let the computer hibernate, when it wakes all is as I expected and was previously, no connection error.

What is confusing me (and maybe my original question is not completely accurate), If I disable the network card with FF28 installed and then do a manual refresh I INSTANTLY get the connection error.

So an auto refresh under FF28 waits until there is a connection and then refreshes, but a manual one times out instantly. This is actually perfect and what I would like to have under FF50 which in instantly giving me the connection error under both situation.