Avatar for Username

Iskanje po podpori

Izogibajte se prevarantski tehnični podpori. Nikoli vam ne bomo naročili, da pokličete telefonsko številko ali nam pošljete osebne podatke. Sumljivo dejavnost prijavite z gumbom »Prijavi zlorabo«.

Več o tem

Ta tema je arhivirana. Postavite prosim novo vprašanje, če potrebujete pomoč.

I set Inbox "Properties" to search for a From & To string and now cannot undo it.

  • 4 odgovori
  • 2 imata to težavo
  • 4 ogledi
  • Zadnji odgovor od Zenos

Curt_Dunnam
Curt_Dunnam
more options

How do I get back to the normal, unfiltered Inbox function, free of any search criteria or null entries in the window that opens under Inbox>Properties? If I delete my search criteria, NO messages can be read. I don't see any obvious way to undo the overriding behavior of this search filter window! I would normally expect a "Cancel" button or some obvious way to turn off this Inbox search/filter function— Thx, Curt

How do I get back to the normal, unfiltered Inbox function, free of any search criteria or null entries in the window that opens under Inbox>Properties? If I delete my search criteria, NO messages can be read. I don't see any obvious way to undo the overriding behavior of this search filter window! I would normally expect a "Cancel" button or some obvious way to turn off this Inbox search/filter function— Thx, Curt

Vsi odgovori (4)

Zenos
Zenos
more options

I can't make any sense of your question. How does a folder's properties relate to filtering or sorting?

Zenos
Zenos
more options

Check your QuickFilter Bar.

Curt_Dunnam
Curt_Dunnam Lastnik vprašanja
more options

Thanks for your reply—however, I checked the Quickfilter bar but did not find anything there affecting the Inbox Properties filter. After exploring a few additional dead ends, I finally tried the Inbox Properties window "Match All" option, which in spite of its ambiguous label seemed to remove all the filtering constraints and thus solved the problem. Attention T-bird moguls and developers: if the button really undoes the Properties filter constraints, it should be labeled "Allow All", not "Match All". Thx again, Curt

Zenos
Zenos
more options

Those terms would appear to relate to the Message Filter dialogue. If so, I don't understand why you refer to them as "properties".

Can you please provide a screenshot of the screen, window or dialogue where you set "Match All"?