Avatar for Username

Sök i support

Akta dig för supportbedrägerier: Vi kommer aldrig att be dig att ringa eller skicka ett sms till ett telefonnummer eller dela personlig information. Rapportera misstänkt aktivitet med alternativet "Rapportera missbruk".

Läs mer

Denna tråd har arkiverats. Ställ en ny fråga om du behöver hjälp.

TB 52.5.2 doesn't have "change delay for marking read" at tools->options->...Advanced, so posted solutions don't apply!

  • 2 svar
  • 1 har detta problem
  • 1 visning
  • Senaste svar av rlwilsonjr

rlwilsonjr
rlwilsonjr
more options

I used to get several seconds to glance at an incoming message before it was marked read. I want that back. Several posts say to go to Tools->Options->Display->Advanced, but there is no place there to set a delay in TB 52.5.2! How can I get that back?

I used to get several seconds to glance at an incoming message before it was marked read. I want that back. Several posts say to go to Tools->Options->Display->Advanced, but there is no place there to set a delay in TB 52.5.2! How can I get that back?

Vald lösning

Here it is under the equivalent of

Tools|Options|Display|Advanced

My screenshot was made on a Linux system, where the entry route is Edit|Preferences rather than Tools|Options, but thereafter it is the same dialogue.

I invite you to post your own screenshot demonstrating how our setting dialogues differ.

Läs svaret i sitt sammanhang 👍 3

Alla svar (2)

Zenos
Zenos
more options

Vald lösning

Here it is under the equivalent of

Tools|Options|Display|Advanced

My screenshot was made on a Linux system, where the entry route is Edit|Preferences rather than Tools|Options, but thereafter it is the same dialogue.

I invite you to post your own screenshot demonstrating how our setting dialogues differ.

Ändrad av Zenos

rlwilsonjr
rlwilsonjr Frågans ägare
more options

I see what I did wrong: Tools|Options|Display|Advanced I got to, except that I used the wrong "Advanced". There was also a TAB marked Advanced and apparently I mistakenly used that. Thanks for making me try it again, this time I got it right!